A22-Ether
A22-Ethernet Communications A
net Communications Adapter – optional
dapter – optional
Shown directly to bottom-left of Main Control Board (A1) on silkscreen. Plugs into Main Board at
P13. Supports DNP3 and Modbus protocols via 10/100 copper Ethernet connection.
C2-Eliminator F
C2-Eliminator Filter Capacitor – optional
ilter Capacitor – optional
Shown below Power Board on silkscreen. Mounted on bottom-left under Power Board. Provides
the additional ripple filtering required for the ‘filtered eliminator’ option.
CB1-
CB1-A
AC Input Cir
C Input Circuit Br
cuit Break
eaker
er
Located in center of ATevo, about one third from bottom. Protects ATevo ac wiring, and can be
used to disconnect from its ac source.
CB2-DC Output Cir
CB2-DC Output Circuit Br
cuit Break
eaker
er
Located at bottom-center below AC breaker. Protects ATevo dc wiring, and can be used to
disconnect ATevo from battery and system dc load(s).
L1-Main F
L1-Main Filter Inductor
ilter Inductor
Shown in center of silkscreen. Located on bottom-left of back wall. It is part of the dc filter,
lowering ripple
L2-Secondary F
L2-Secondary Filter Inductor
ilter Inductor
Shown bottom-center of silkscreen. Located on bottom of back wall to right of Filter Inductor
(L1). It is also part of the dc filter.
T1-P
T1-Power Isolation T
ower Isolation Transfor
ransformer
mer
Shown near center of silkscreen. Located on back wall above the filter inductors (L1/L2).
Provides isolation and converts ac input voltage to appropriate potential prior to rectification.
Last modified: 11 May 2021
4.2.
4.2. Mechanical Diagram (75-100 Adc)
Mechanical Diagram (75-100 Adc)
The Single Phase Input, Group II ATevo which has an output range of 75-100 Adc has the
following mechanical layout and wiring diagram screen-printed onto its patented, internal
protective Plexiglas shield.
HindlePower Inc
ATevo Operations–Single Phase Input–Group II (30-100 Adc Output) - 1_en
Copyright HindlePower Inc. 2021
Page 27 of 171
