Page
Rev. 3
8
the receiver will stop at that channel and continue to search when that transmission ceased.
There are 4 Scan modes available – All SCAN, Memory Scan,Priority Scan & memory
Scan, Default is All Scan
1
、
At the normal mode,short press the SCAN key to activate SCAN function.
2
、
When the radio in the normal mode, All Scan will be initiated. When the radio in the All
Scan mode, all channel will be scan in sequence.
3
、
When the radio in the memory mode, short press SCAN key to initiate Memory Scan,will
be . long press the Scan key will initiate Priority Scan.
During scan,long press SCAN key will activate All Scan or Memory Scan.’’p’’ icon (priority
icon)will lit
The memory channel will be stated whenever signal received. Once the transmission
finished, the SCAN will automatically carry on to searching for next channel.
All Memory Scan
M1 – M2 – M3 - … M10 – M1- …
All Scan
CH1-CH2-CH3-…..-CH88-CH1
Priority Memory Scan
M1 – CH 16 – M2 – CH 16 - … CH 16 – M1 – M16 - …
(M1; M2; M3 means 1
st
, 2
nd
, 3
rd
programmed channel)
Priority All Scan
CH1-CH16-CH2-CH16-CH3-CH16-…..CH88-CH16-L1-CH16-…
(The radio only has L1 as its private channel)
B.10 MEM
Press the MEM to enter the memory mode when there is at least one channel in the
memory. The channel sequences will follow the programmed channels in the memory. The
“MEM” icon will be turned on. Short press the SCAN will start MEMORY SCAN
Adding CH from the memory:
1. During the normal mode, use the UP/DOWN key to select the desired channel for
programming.
2. Long press the MEM key to store up the channel as memory channel.The “M” icon
shows up to indicate the current channel has been saved in the memory. No limited of
memory channels.
3. Separate memory channel exists for USA, International, and Canadian Frequency
group.
