06/11
Page 7
Adjusting product stops
Loosen the knurled screws of the band guides
(7 + 8)
and set
the desired loop width (approx. 1/3 longer than the product
width). Fix the guides by tightening the knurled screws
(11)
again.
Caution
!
Adjust the guides in a way that the hole of the photoel-
ectric barrier
(12)
is located near the center of the pro-
duct.
Loosen the knurled screws to set the product stops
(13 + 14)
to the desired product length and tighten the
knurled screws again to fix the stops.
Setting length of band loop
The knob
(15)
to adjust the length is located on the operating
PCB which is mounted to a bracket
(16)
in the machine. Turn
the knob
(15)
into the
(–)
direction to reduce the length of the
band loop and into the
(+)
direction to increase it.
Single-stroke operation mode
Turn on the main switch
(17)
at the back of the machine.
Press the On/Off button
(18)
at the control panel, the On/Off
button will flash (heating will take 2 - 3 minutes).
Wait for the On/Off button to show permanently. The machine
is now ready for use.
Load the items to be banded onto the machine table. The
start button
(19)
will flash.
Press the start button or the foot actuator (the foot actuator
must be connected to the remote operation socket located at
the back of the machine).
The items will be banded.
HIMA
Harald Hinderer Maschinenbau