Hilti GTB 6X-22, Руководство пользователя

Страница: 17 / 60

*2332219*
2332219 English 11
1. Remove the abrasive belt. → page 8
2. Detach the worn felt pads from the gear head and the swing arm.
3. Peel the backing foil off the adhesive side of the new felt pads.
4. Affix the new felt pads to the gear head and the swing arm.
7.2 Changing the drive roller 6
A worn drive roller can be replaced.
1. Remove the abrasive belt. → page 8
2. Press and hold down the spindle lock button.
3. Unscrew the drive roller by turning it counter-clockwise.
4. Screw the new drive roller on to the spindle.
5. Release the spindle lock button.
7.3 Changing the guard 7
The guard protects the gear head from damage by the abrasive belt. It can be replaced when worn.
1. Remove the abrasive belt. → page 8
2. Remove the drive roller. → page 11
3. Remove the securing screws and lift off the guard.
4. Hold the new guard in position, install the securing screws and tighten them to the specified torque.
Technical data
Tightening torque, securing screws for guard 2.4 Nm
(1.8 ftlb
f
)
5. Install the drive roller.
7.4 Changing the guide roller / relay roller 8
The guide roller and relay roller can be replaced when worn or damaged.
1. Remove the abrasive belt. → page 8
2. Remove the securing screw and remove the roller. If necessary, use an open-ended wrench to lock the
shaft.
3. Insert the new roller and install the securing screw.
4. Lock the shaft with an open-ended wrench and tighten the securing screw to the specified torque.
Technical data
Tightening torque, securing screw for guide roller⁄relay roller 8 Nm
(6 ftlb
f
)
8 Transport and storage of cordless tools and batteries
Transport
CAUTION
Accidental starting during transport !
▶
Always transport your products with the batteries removed!
▶
Remove the battery/batteries.
▶
Never transport batteries loose and unprotected. During transport, batteries should be protected from
excessive shock and vibration and isolated from any conductive materials or other batteries that may
come in contact with the terminals and cause a short circuit. Comply with the locally applicable
regulations for transporting batteries.