Hilti DST 10-CA, Руководство по эксплуатации

Страница: 49 / 52

*2328079*
2328079 English 45
Trouble or fault Possible cause Action to be taken
The saw blade is
jammed in the kerf and
the saw doesn’t start.
A piece of steel cut free is
jammed in the kerf.
▶
Try to lift the saw blade
out of the kerf by alter-
nately moving the saw
head forward and back
(advance / return). Try to
start the blade drive as
soon as the blade can be
moved freely. Caution!
Avoid use of excessive
force as this could result
in damage.
▶
If the saw blade can’t
be moved: Disconnect
the saw blade from the
saw and use a breaker
/ jackhammer to chisel
away concrete until the
blade is free.
The part cut free is pressing
against the saw blade.
▶
Disconnect the saw blade
from the saw.
▶
Remove the part that has
been cut free.
Saw blade slips Tightening torque too low
▶
Grease the thread of
the clamping screw and
tighten the clamping
screw to the specified
torque.
Clamping faces of flange
and saw blade dirty or oily
▶
Clean and degrease the
clamping surfaces.
Threads of clamping screw
and inner flange dirty or
damaged
▶
Clean and check the
threads of clamping screw
and inner flange.
Thread of the clamping
screw is stiff
▶
Grease the thread of the
clamping screw.
13 China RoHS (Restriction of Hazardous Substances)
The following link takes you to the table of dangerous substances: qr.hilti.com/r000000.
There is a link to the RoHS table, in the form of a QR code, at the end of this document.
14 Disposal
Most of the materials from which Hilti products are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries,
your old tools, machines or appliances can be returned to Hilti for recycling. Ask Hilti
Service or your Hilti sales representative for further information.
In accordance with the European Directive on waste electrical and electronic equipment
and its implementation in conformance with national law, electric tools, machines or