hilscher 1912.112, Руководство пользователя

Страница: 52 / 154

Configuration 52/154
8.3.7.1 Port settings
Use the Settings tab to view and change the port settings individually.
Ø
Select the desired wireless port (WP01, WP02, WP03, ...) in the left
column of the netFIELD Wireless Web Server.
Ø
Open the Settings tab with its sub tabs.
Ê The Port cycle sub tab appears by default.
Settings > Port cycle
Figure 16: Settings tab, Port cycle sub tab (example)
Parameter Description Value / Value range
Port mode Operating mode of IO-Link port
· Deactivated: The port is inactive, Input and Output Process Data
is 0.
· Cyclic
· Roaming
Deactivated, Cyclic, Roaming,
Default: Deactivated
Port cycle time
Port cycle time expected by the SMI client
The expected cycle time of the port is set depending on the
selected operating parameters.
See table Calculation of the port
cycle time of the IO-Link
Wireless Master
[
}
page 53].
Time base: Used time base for the calculation of the port cycle
time. Free running, 5 ms
Time multiplier: Used factor for the calculation of the port cycle
time. 0 … 63
Table 28: Settings in port configuration for IO-Link Device, Port cycle sub tab
* Values are in hexadecimal
Ø
Configure port operating mode Port mode by selecting the
corresponding option.
Ø
Configure the “Port cycle time”.
The parameter “Port cycle time” sets up the cycle time of a W-Port of the
W-Master. The cycle time is encoded using "Time base" (bits 6+7) and
"Multiplier" (bits 0-5) values, as shown in the following table:
NFD-3090-EIS-IOLM\W | Hardware, installation and commissioning
DOC200701UM02EN | Revision 2 | English | 2021-08 | Released | Public © Hilscher 2020 - 2021