31
Chapter 2 Installation Preparation
|
Hillstone
Hillstone SG-6000 X-Series Hardware Reference Guide
Unpacking the Package of SG-6000-X10800
SG-6000-X10800 is wrapped in the wooden case. The wooden case consists of
wooden panels, steel edges, tongues and EPE. Besides the chassis, the wooden case
also contains the accessory box.
The wooden case is 830.0mm long, 620.0mm wide and 1035.0mm high. The total
weight of packaging materials and the hardware is 165.0kg.
Note
: The device is maximally protected inside the shipping wooden case. Do not
unpack it until you are ready to begin installation.
To unpack the package, take the following steps:
1.
Move the shipping wooden case to a place as close to the installation site as
possible, where you have enough room to remove packages (you are suggested
to use a forklift or cart).
2.
Position the wooden case with the arrows pointing up.
3.
There’re many tongues in the wooden case. You are suggested to remove the
tongues around the bottom of the wooden case.
Figure 2-1: Position of Tongues to be Removed
4.
Insert the straight screwdriver into the hole of the tongue from above, and then
make the tongue level.
Note: The edges of tongue are sharp and may cause injury.