Hillrom Compella, Инструкция по эксплуатации

Страница: 42 / 116

Standard Features
28 Compella™ Bariatric Bed System Instructions for Use (178951 REV 6)
Bed Up/Down
WARNING:
To help prevent personal injury and/or equipment damage, obey these warnings:
• Warning —Put the bed be in the low position when the patient is unattended.
• Warning —Make sure no person or stored equipment is under the bed when
you lower it.
The caregiver can adjust the bed height from a low position for patient exit to a high
position for examination.
To raise —press and hold the Bed Up control until the bed is at the desired height. You
will hear a single beep when the bed is at its highest position.
To lower —press and hold the Bed Down control until the bed is at the desired height.
You will hear a single beep when the bed is at its lowest position.
NOTE:
The Bed Not Down indicator comes on when the bed is not at the lowest bed height.
Head Up/Down
The caregiver can adjust the head section to specific angles. The maximum travel for the
head section is 50°.
To raise —press and hold the Head Up control until the bed is at the desired height.
To lower —press and hold the Head Down control until the bed is at the desired height.
NOTE:
The Auto Contour™ feature is not active when you use the caregiver controls; it is only
active when you use the patient controls. see “Standard Patient Controls” on page 25.
Knee Up/Down
The caregiver can raise or lower the knee section. The knee section has a maximum
travel of 30°.
To raise —press and hold the Knee Up control until the bed is at the desired height.
To lower —press and hold the Knee Down control until the bed is at the desired height.
NOTE:
To put the bed in an auto contour position, press the Head Up and Knee Up controls at
the same time.