Hill-Rom VersaCare, Краткое руководство пользователя, Страница: 3 / 16

Page 3 of 16
For detailed Warning and Caution statements, and operating
instructions, refer to the
VersaCare® Bed User Manual (USR119
for A through J models; 161956 for K model and newer).
Emergency CPR and
Trendelenburg and
Safety and Information
Indicators
Bed
Emergency CPR
The emergency CPR controls are handles
located under the sleep deck, between the head
and intermediate siderails on both sides of the
bed.
NOTE: The headboard can be used as a CPR
board.
1. Pull and hold the
CPR handle. If the bed has
an treatment/therapy surface, the surface
will go into Max-Inflate.
2. Hold the CPR handle until the head and
knee section come to a stop in the flat posi-
tion.
3. Release the CPR handle.
Emergency Trendelenburg
The emergency Trendelenburg controls are
handles located under the sleep deck, between
the head and intermediate siderails on both
sides of the bed. The handles used to operate
CPR are also used to operate emergency Tren-
delenburg.
NOTE: There must be power to the bed, either
AC or battery, for the Emergency Trendelenburg
function to operate.
1. Make sure the bed is plugged into AC power
or the battery is activated.
2. Pull and hold the CPR handle.
3. Hold the CPR handle until the head and
knee section come to a stop in the flat posi-
tion.
4. Continue to hold the CPR handle until you
reach the applicable bed angle.
5. Release the CPR handle.
Safety and Information
Indicators
NOTE: For the indicators to oper-
ate, there must be AC or battery
power to the bed.
NOTE: A through F models have the wrench
(Service is Required) indicator only .
Plug (Disconnected from AC Power)
If the bed is disconnected from AC power and
the battery is active, the plug indicator flashes.
Wrench (Service Is Required)
When the wrench indicator comes on solid or
flashes, contact your facility-authorized mainte-
nance person.
Battery
• ON = battery is active.
• FLASHING = battery needs to be charged.
• OFF = battery is inactive or is discharged
below the level necessary to operate the
motors.
Brake Not Set
If the bed is connected to AC power, and the
brake is not set, the Brake Not Set indicator
(available on some beds) flashes and a continu-
ous alarm comes on. Set the brake to stop the
alarm.