background image

Liko UniversalSling  •  7EN160174-04

Carefully remove the leg supports.

The gentlest way of doing this is by pulling out 

the leg support loops under the fabric part.

Remove the sling by carefully pulling it up.

We recommend removing the sling after the transfer. If for some reason it is preferable to leave the sling in the chair, 

we recommend using a sling made of net polyester.

Removing the Sling in a Chair/Wheelchair 

Lifting from the Bed

We recommend applying the sling when the patient is lying horizontally, as this is the easiest procedure. In some cases, 

e.g., if the patient cannot lie horizontally, the sling can be applied with the patient sitting up in bed (see 

Alternative 

method of applying the sling

 below)

.

For lifting from a supine position without the possibility of raising the head end of the bed, we recommend Liko Soft 

Original HighBack Sling Mod. 26, or alternatively Liko Original HighBack Sling Mod. 20, 21, which all provide support 

for the head.
Think about your own work posture as well as the comfort of the patient. Use the bed’s raising and lowering functions.

Turn the patient toward you to 

prevent him or her from falling out 

of the bed. Insert the sling’s edge 

under the patient with the lower 

edge level with the coccyx. Fold 
the sling so that its centre back 
strap corresponds to the patient’s 

spine when the patient is turned 

back again gently. Carefully pull 

the sling out from the other side. 

Raise the head end of the bed. First 

connect the upper strap loops to the 

sling bar, then the leg support loops. 

Lift.

Insert the leg supports under each 

leg. This is best done by pressing 

the leg support down against the 

mattress while inserting it under 

the thigh.

Make sure the fabric lies flat and 

that it reaches properly around 
the leg. The leg supports can be 

connected in different ways, see 

page 7.

Alternative method of applying the sling: 

Raise the head end of the bed behind the patient. Lay the sling 

on the bed with the product label facing down towards the mattress. Slide the sling down behind the patient’s 

back so that the lower edge 

is in level with the coccyxTip!

 The application is facilitated if the patient leans/

is leaned forward.

Содержание Liko UniversalSling









Отзывы: