Hill-Rom Excel Care, Руководство пользователя, Страница: 20 / 60

5. Do one of these:
• To save the changes and start normal weight monitoring, press the Hold control
again.
• To erase the changes, press the Weigh control.
Disconnect Power When the Scale is in Use
If it becomes necessary to disconnect the bed’s power when the scale is in use, such as for
patient transport, do as follows:
1. Before disconnecting the bed’s power, note the shown patient weight.
2. Unplug the bed from its power source.
3. Move the bed and/or patient as necessary.
4. When the patient is in the correct position, plug the bed into an appropriate power
source. The display shows Power Interrupted and then Press +.
5. Examine the shown patient weight:
• If the shown patient weight is correct, the system is ready.
• If the shown patient weight is not correct, manually correct it (see “Correct the
Shown Patient Weight” on page -18).
• If the patient’s weight is not known, remove the patient from the bed, and zero the
scale (see “Zero the Scale” on page -18).
Adjust the Width of the Bed
To increase or decrease the width of the bed, extend or retract
each bed width extender on both sides of the bed. Simultaneously
push the blue release knob and slide the bed width extender in or
out until the bed is at the applicable width. Make sure the release
knob springs back into the locked position.
Use the Bumpers
Bumpers, at the head end of the bed, help protect the bed, wall,
and any headwall system from damage.
19