4. Check Enable after successful calibration.
5. Click Save.
4.10 Set Panorama Tracking
The PTZ channel tracks detected target after panoramic channel and PTZ channel.
Steps
1. Go to Configuration → PTZ → Panorama Tracking .
2. Select calibration mode.
Auto Calibration
Select the Calibration Mode as Auto, and click Start Calibration. The
device starts calibration automatically.
After calibration finished, click Stop Calibration and exit the interface.
Manual
Calibration
Select and add calibration positions manually. The detailed manual
calibration configuration is as follows.
1) Select the Calibration Mode as Manual
2) Select a calibration point in Calibration Parameter list.
A numbered green cross is displayed on the panoramic image. You can drag the green cross
to adjust its position.
3) Click Add to save the cross position in the panoramic channel.
4) Adjust PTZ to place the green cross in the PTZ camera channel to the same position as the
green cross in panoramic camera channel. 1× zoom ratio is recommended.
Note
To quickly locate the desired point in the PTZ channel, you can click and click the target
position in the PTZ channel.
5) Click to save the PTZ position of this calibration point.
6) Repeat the steps above to set at least 4 calibration points.
7) Click Start Calibration.
3. Check Track.
4. Click Save to finish calibration.
4.11 Set Power Off Memory
This function can resume the previous PTZ status of device after it restarting from a power-off.
Steps
1. Go to Configuration → PTZ → Basic Settings .
2. Select Resume Time Point. When the device stays at one position for the set resume time point
or more, the position is saved as a momory point. The device returns to the last memory point
when it restarts.
3. Click Save.
Target Capture Camera User Manual
32