5 Local Operation
5.1 Local Configuration
5.1.1 Edit Network Parameters
After activating, you should edit the network parameters.
Steps
1. Hold * and # at the same time to enter the authentication page.
2. Authenticate via administrator.
-
Authenticate face/card/fingerprint to login.
-
Press # to enter the password to login.
3. Swritch to Network settings according to the tips on the page. Press # to enter
the settings page.
4. Edit the parameters according to your needs.
5. Press * to save and exit.
5.1.2 Door Station Settings
Edit the parameters of the door station (including but not limited to, community No.,
building No., floor No., room No. and device mode).
Steps
1. Configure the parameters according to the actual needs.
Note
• Outer door station can only edit the Community No., Project No. and No.
• The No. of the main door station is 0.
• The No. of sub door stations should be larger than 0 and ranges from 1 to 99.
• Each unit should add 1 main door station. Up to 8 sub door stations can be
added to the main door station.
2. Optional: Adjust the brightness of the screen.
3. Optional: Enable the Channel Mode according to your needs.
4. Optional: Select the language.
Video Intercom D Series Door Station User Manual
25
