HIKVISION K1T671, Быстрый старт

Страница: 4 / 6

将明眸的 wiegand 线，接到 26 控制器上，电源线可以单独供电，如下图。注意：W0、W1
和 GND 必须要接上，其他线不接不会影响卡号传输。
Connect the wiegand cable of MinMoe to the 26 serial controller, and the power cable can
supply power separately, as shown in the figure below. Note: W0, W1 and GND must be
connected, other lines will not affect the card number transmission.
2、配置 Configuration
Wiegand 配置我们需要选择方向为输出方向，模式有 wiegand26 和 wiegand34.可通过如
下 3 种方式任选其一设置参数。
For Wiegand configuration, we need to select the direction as the output direction. The
modes have wiegand26 and wiegand34. You can choose one of the following three ways
to set the parameters.
(1)设备本地设置：
(1) Device Local Settings: