User Manual of DS-TRI4XX-X Series Bluetooth Card Reader
10
Chapter 3 Function Configuration
Before you can configure the functions of the device, first enter configuration mode: press and
hold S2 button for about 2 seconds, and release the button after hearing a long buzzing sound to
enter configuration mode. After function configuration is finished, press and hold the S2 button
again for about 2 seconds or wait for 6 seconds to exit configuration mode.
If the device is installed in outdoor environment, turn the operating mode switch to ON (the
side with
sign), or to the other side for indoor installation.
3.1 Setting Card No. Upload Delay
Step 1
After entering configuration mode, press S2 button until LED
flashes.
Step 2
Press S1 button to set the delay. Press the button once to set one second delay, e.g.,
pressing the button x times will set a delay of x seconds.
Step 3
The buzzer will send x buzzes to indicate that a delay of x seconds.
The delay can be set from 1 to 20 seconds. The default setting is 3 seconds.
3.2 Setting Loop Signal Trigger
Step 1
After entering configuration mode, press S2 button until LED
flashes.
Step 2
Press S1 button to enable or disable the trigger. The trigger is enabled if the indicator is on,
or disabled otherwise. The function is disabled by default.
3.3 Setting Relay
Step 1
After entering configuration mode, press S2 button until LED
flashes.
Step 2
Press S1 button to enable or disable relay function. The relay is enabled if the indicator is on,
or disabled otherwise. The function is disabled by default.
