User Manual of Parking Camera
85
Figure 12-16
RS-485 Settings
2.
Set the RS-485 parameters and click
Save
to save the settings.
By default, the Baud Rate is set as 9600 bps, the Data Bit is 8, the stop bit is 1 and the
Parity and Flow Control is None.
Note:
The Baud Rate, PTZ Protocol and PTZ Address parameters should be exactly
the same as the PTZ camera parameters.
12.8
Service Settings
Purpose:
Telnet function provides an easy way to get access to the camera. You can see the
advanced information about the camera by inputting command; as well the
configuration can also be realized through telnet connection.
Steps:
1.
Go to Configuration> Advanced Configuration> System > Service to enter the
service settings interface.
2.
Check the checkbox of Telnet.
3.
Click the
Save
button to save the settings.
