DS-KABD8003-RS3/S
Module Door Sta�on Protec�ve Shield
Diagram References
E N G L I S H
Appearance and Dimension
Installa�on
Before you begin:
Surface Moun�ng with Protec�ve Shield
2
1
1. Make sure the device in the package is in good condi�on and all the assembly parts are
included.
2. Make sure the place for surface moun�ng is flat.
3. Tools that you need to prepare for installa�on: Drill (ø6), cross screwdriver (PH1*150
mm), and gradienter.
4. Make sure all the related equipment is power-off during the installa�on.
1. Paste the installa�on S�cker 1 onto the wall. Make sure the s�cker is placed leveled via
measuring with the gradienter. Drill 4 holes align to the screw holes on the s�cker.
Note:
The suggested size of hole is 6 (diameter) × 25 (depth) mm.
The suggested length of cables le� outside is 100 mm.
2. Remove the s�cker and insert the expansion sleeves into the screw holes.
Fix the moun�ng frame and protec�ve shield onto the wall with 4 expansion bolts.
Thread the module-connec�ng lines across the thread holes of the frame.
Pass the main unit connec�ng lines across the thread hole to the top grid.
Connect the cables and module-connec�ng line 1 to the corresponding interfaces of the
main unit, then place the main unit into the upper grid.
Connect the other end of the module-connec�ng line1 to the input interface of the sub
module. Connect two sub modules via module-connec�ng line 2.
Organize the line with cable �e in the package.
3. Insert the modules in to the frame a�er wiring. Main unit must be placed in the top grid.
4. Use the hexagon wrench in the package fix the cover onto the frame.
Refers to the figure and table below to see the details.
Note: The protec�ve shield is used to installing the 3-module door sta�on.
UD22617B
1
1
2
3
4
Cable Hole
Screw Hole
Cover
Hexagonal
Screw
Sub Module
Main Unit
Expansion
Bolts
Moun�ng
Frame
Protec�ve
Shield
