HIKVISION DS-K3B601-L Series, Быстрый старт

Страница: 34 / 38

Swing Barrier
·
Quick Start Guide
26
Appendix A DIP Switch Description
DIP Switch Introduction
There are two groups of DIP switches on the master lane control board. Take the 8-bit DIP switch as
an example; No.1 to No 8 is from the low bit to the high bit.
When the switch is towards ON, it means the switch is enabled, otherwise, the switch is off.
If you set the DIP switch like the figure displayed below, its binary value is 00001100, and its
decimal value is 12.
DIP Switch Corresponded Functions
The 8-bit DIP switch corresponded functions on the master lane control board are as follows:
Bit Function Decimal Value Binary Value
1 to 2
Normal Mode 0 00
Study Mode 1 01
Test Mode 2 10
3
Enable Memory Mode 0 0
Disable Memory Mode 1 1
4
Allow Opening Barrier by
Swiping Card in Alarm Area
0 0
Prohibit Opening Barrier by
Swiping Card in Alarm Area
1 1
5 to 8
Controlled Bi-direction 0 0000
Controlled Entrance and
Prohibit Exit
1 0001
Controlled Entrance and Free
Exit
2 0010
Free Bi-direction 3 0011
Free Entrance and Controlled
Exit
4 0100
Free Entrance and Prohibit Exit 5 0101
Prohibited Bi-direction 6 0110
Prohibit Entrance and
Controlled Exit
7 0111
Prohibit Entrance and Free Exit 8 1000