9.7 Network Parameters Settings
Set device network parameters, including the NIC type, DHCP, and HTTP.
On the Device for Management page, click → Network → Network Parameters to enter the
Network Parameters Settings tab.
NIC Type
Select a NIC type from the drop-down list. You can select either Self-adaptive, 10M, or 100M.
DHCP
If you disable the function, you should manually set the device's IPv4 address, IPv4 subnet
mask, IPv4 default gateway, MTU, and port.
If you enable the function, the system will automatically assign IPv4 address, IPv4 subnet mask,
IPv4 default gateway for the device.
HTTP
Set the HTTP port, DNS1 server address, and DNS2 server address.
9.8 Report Strategy Settings
You can set the center group for uploading the log via the EHome protocol.
On the Device for Management page, click → Network → Report Strategy to enter the Report
Strategy Settings tab.
You can set the center group and the system will transfer logs via EHome protocol. Click Save to
save the settings.
Center Group
Select a center group from the drop-down list.
Main Channel
The device will communicate with the center via the main channel.
Note
N1 refers to wired network.
9.9 Network Center Parameters Settings
You can set the notify surveillance center, center's IP address, the port No., the protocol (EHome),
the EHome account user name,etc. to transmit data via EHome protocol.
On the Device for Management page, click Remote Configuration → Network → Network Center
Parameters to enter the Network Center Parameters Settings tab.
Select a center from the drop-down list.
DS-K1T804B Series Fingerprint Access Control Terminal User Manual
124
