Note
The device's IP address and the computer IP address should be
in the same IP segment.
5. Tap to save the network parameters.
6.4.2 Set Wi-Fi Parameters
You can enable the Wi-Fi function and set the Wi-Fi related
parameters.
Steps
1. Tap Comm. (Communication Settings) on the Home page to
enter the Communication Settings page.
2. On the Communication Settings page, tap Wi-Fi to enter the
Wi-Fi tab.
Figure 6-7 Wi-Fi Settings
3. Enable the Wi-Fi function.
4. Select a Wi-Fi in the list to enter the Wi-Fi parameters settings
page.
5. Select an IP mode.
-
If selecting Static, you should input the Wi-Fi password, IP
address, subnet mask and gateway.
-
If selecting Dynamic, you should input the Wi-Fi password.
Note
Numbers, upper case letters, lower case letters, and special
characters are allowed in the Wi-Fi password.
6. Tap OK to save the settings and go back to the Wi-Fi tab.
7. Tap to save the network parameters.
6.4.3 Set RS-485 Parameters
The face recognition terminal can connect external access
controller, secure door control unit or card reader via the RS-485
terminal.
Steps
1. Tap Comm. (Communication Settings) on the Home page to
enter the Communication Settings page.
2. On the Communication Settings page, tap RS-485 to enter the
RS-485 tab.
3. Select an external device according to your actual needs.
21
