HIKVISION DS-K1T605 Series, Руководство пользователя

Страница: 80 / 107

5. Enable the event so that when the event is detected, en event
will be sent to the client and the linkage actions will be
triggered.
6. Optional: Click Copy to... to copy the event settings to other
access control device, alarm input, door/elevator, or card
reader.
9.5.2 Configure Device Actions for Access Event
You can set the access control device's linkage actions for the
access control device's triggered event. When the event is
triggered, it can trigger the alarm output, host buzzer, and other
actions on the same device.
Steps
Note
It should be supported by the device.
1. Click Access Control Linkage Configuration .
2. Select the access control device from the list on the left.
3. Click Add button to add a new linkage.
4. Select the event source as Event Linkage.
5. select the event type and detailed event to set the linkage.
6. In the Linkage Target area, set the property target to enable
this action.
Buzzer on Controller
The audible warning of access control device will be
triggered.
Capture
The real-time capture will be triggered.
Recording
The recording will be triggered.
Note
The device should support recording.
Buzzer on Reader
The audible warning of card reader will be triggered.
Alarm Output
The alarm output will be triggered for notification.
Alarm Input
Arm or disarm the alarm input.
Note
The device should support alarm input function.
Access Point
The door status of open, close, remain open, and remain
close will be triggered.
Note
The target door and the source door cannot be the same
one.
Audio Play
71