DS-8000AHI/AHLI/AHFLI-S Embedded Net DVR
Page
61
Total
116
5.10 Motion Detection Alarm
If you enable this function, when there is motion detected, DVR will make alarm.
Step 1: Enter into “Image Setup” menu:
Step 2: Select camera:
Use
【
】【
】
key to select one camera.
Step 3: Select motion detection sensitivity:
On the right side of “Motion Det. Level” item,
there is a list box. That is motion detection sensitivity. There are 7 options, from 0 (the lowest) to
5 (the highest) and “Off”. You can use
【
↑
】
【
↓
】
keys to select one. If you select “Off” option, DVR
will not response even if there is motion detection. If you select other options, it’ll active “Motion
Area Setup” button and “Policy Setup” button. If you select low sensitivity such as 0, only when
there are great motion detection, DVR can response. On the other side, for high sensitivity such as
5, DVR will response with small motion detection.
Step 4: Motion area setup:
You must define motion areas so that DVR will response when
there is motion in those areas. Move “Active Frame” to “Area” buton on the right side of
sensitivity list box, press
【
ENTER
】
key, you can enter into “Motion Area Setup” interface.
The whole screen is divided into 22*18 panes (NTSC: 22*15). There is one yellow panel on
the upper left side. The motion area setup steps are the same as that of mask area setup (refer to
chapter 5.7). The only differences are that you can use
【
PTZ
】
key to set the whole screen as motion
area, and mutil motion areas can be defined.
Press
【
A
】
key to clear all motion areas.
Setup multi areas:
After you setup one motion area, press
【
EDIT
】
key, the yellow pane will
appear again, then you can setup another motion area.
Clear motion area:
Clear part of motion area:
Move the yellow pane to the start clear position of motion area,
