HIKVISION DS-6600 Series, Руководство пользователя

Страница: 65 / 82

User Manual of DS-6600 Audio/Video Encoder
64
Figure 8.21 Tamper-proof Alarm Settings
3. Click checkbox of Enable Tamper-proof .
4. Set the tamper-Proof area. Please refer to Step 1 Set the Motion Detection Area in Chapter 8.3.1.
6. Click Edit to edit the arming schedule for tamper-proof. The arming schedule configuration is the same as
the Setting of the Arming Schedule for Motion Detection. Please refer to Step 2 Set the Arming Schedule for
Motion Detection in Section 8.3.1 Configuring Motion Detection.
7. Click the Linking Method tab to set the actions taken for the tamper-proof alarm. Please refer to Step 3 Set
the Alarm Actions Taken for Motion Detection in Section 8.3.1 Configuring Motion Detection .
8.3.5 Handling Exception
The exception type can be HDD full, HDD error, network disconnected, IP address conflict, illegal access, video
standard mismatch, video signal exception, record/capture exception and video resolution mismatch.
Note: When the selected resolution under Remote Configuration > Camera Settings >Video Settings and the
actual video input resolution are mismatched, the exception alarm will occur. Please refer to Section 8.2
Configuring Video Settings.
Steps:
1. Click Remote Configuration> Exception to enter the Exception Settings interface.
2. Check the checkbox to set the actions taken for the Exception alarm. Please refer to Step 3 Set the Alarm
Actions Taken for Motion Detection in Section 8.3.1 Configuring Motion Detection .