HIKVISION DS-2DE4425W-DE3, Руководство пользователя

Страница: 69 / 125

© Hikvision
7. Set threshold level. The level ranges from 5 s to 100 s. If you set the value as 5, alarm is
triggered immediately after the object entering the region.
8. Set sensitivity level. Sensitivity level ranges from 1 to 100. The value of the sensitivity
defines the size of the object which can trigger the alarm, when the sensitivity is high, a very
small object can trigger the alarm.
9. Click tab to enter the arming schedule setting interface. The time
schedule configuration is the same as the settings of the arming schedule for motion
detection. Refer to Section 5.2.1 Configuring Motion Detection.
10. Click tab to select the linkage method taken for the object removal alarm,
Notify surveillance center, send email, upload to FTP, trigger channel, smart tracking and
trigger alarm output are selectable. Refer to Section 5.2.1 Configuring Motion Detection.
11. Click button to save the settings.
5.4 PTZ Configuration

On the event configuration page, click to show the PTZ control panel or click to hide it.

Click the direction buttons to control the pan/tilt movements.

Click the zoom/iris/focus buttons to realize lens control.

The functions vary depending on different camera models.
5.4.1 Configuring Basic PTZ Parameters
You can configure the basic PTZ parameters, including proportional pan, preset freezing, preset
speed, etc.
1.
Enter the Basic Settings interface:
Configuration > PTZ > Basic Settings