HIKVISION DS-2DB4236I-CWX, Быстрый старт

Страница: 13 / 43

Explosion-proof IR Zoom Bullet Camera
·
Quick Start Guide
xii
Repair and overhaul shall comply with IEC 60079-19: latest version
or its National equivalent.
Cleaning
Please use a soft and dry cloth to clean the inner and outer surfaces.
Do not use alkaline detergents.
Keep the surface clean and prevent dust accumulation. DO NOT
clean the surface by compressed air duster.
Do not touch sensor modules with fingers. If cleaning is necessary,
use clean cloth with a bit of ethanol and wipe it gently. If the camera
will not be used for an extended period, please replace the lens cap
to protect the sensor from dirt.
Using Environment
When any laser equipment is in use, make sure that the device lens
is not exposed to the laser beam, or it may burn out.
DO NOT aim the lens at the sun or extra bright places. A blooming or
smear may occur otherwise (which is not a malfunction however),
and affecting the endurance of sensor at the same time.
To avoid heat accumulation, good ventilation is required for a proper
operating environment.
DO NOT expose the device to extremely hot, cold, dusty, corrosive,
saline-alkali, or damp environments. For temperature and humidity
requirements, see device specification.
DO NOT expose the device to high electromagnetic radiation.
Emergency
If smoke, odor, or noise arises from the device, immediately turn off
the power, unplug the power cable, and contact the service center.