For cement wall/ceiling, expansion bolts are
required to fix the camera. For wooden
wall/ceiling, self-tapping screws are required.
4.
Route the cables through the cable hole, or the side
opening.
5.
Connect the corresponding power cord, and video
cable.
6.
Power on the camera to check whether the image
on the monitor is gotten from the optimum angle. If
not, adjust the camera according to the figure below
to get an optimum angle.
Rotation Position
[0° to 360°]
Pan Position
[0° to 360°]
Tilt Position
[0° to 180°]
P Screw
T Screw
R Screw
Figure 2-3
3-axis Adjustment
1).
Loosen the P screw to adjust the pan position [0°
to 360°]. Tighten the screw after completing the
adjustment.
2).
Loosen the T screw to adjust the tilt position [0°
to 180°]. Tighten the screw after completing the
adjustment.
3).
Loosen the R screw and rotate the camera [0° to
360°]. Tighten the screw after completing the
adjustment.
2.1.2
Ceiling/Wall Mounting with Junction Box
Before you start:
You need to purchase a junction box separately.
Steps:
1.
Paste the drill template on the ceiling/wall.
2.
Drill screw holes and the cable hole in the
ceiling/wall according to the holes of the drill
template.
Figure 2-4
Drill Template of Junction Box
3.
Take apart the junction box, and align the screw
holes of the bullet camera with those on the
Junction box’ cover.
4.
Fix the camera on the junction box’s cover with
supplied screws.