HIK VISION Pyronix Enforcer V10, Расширенное руководство по программированию

Страница: 7 / 56

7
Enforcer V10 Programming Guide
Keypads
Three additional wired keypads may also be connected to the Enforcer.
Key functions

= Exit Engineer and Manager menu / Selects Area A.

= Moves backwards to the previous menu item / Selects Area B.
c
= Enables chime and displays additional information in the log / Scrolls back ‘one’ in a sub menu / Selects Area
C.
D
= Moves forward in the log / scrolls between options and enters the master manager menu /Selects Area D.
f p
= Not used.
[ ]
= Directional buttons.
I
= Selects items and enters menus.
A
= Cancels items, resets the panel and moves to next item in a menu item.
Please note
1. If any additional keypads are installed on the Enforcer, it is possible to access the Engineer Menu on
any keypad. For example, if the Engineer menu is accessed on keypad address 0, the other keypads
will display ‘System Busy’. To access the Engineer menu on any other keypad, press the  key on the
relevant keypad and the Engineer menu will be displayed.
2. A wireless keypad can be connected to set/unset (LEDRKP-WE)
The Internal Tag Reader (EUR-107)
The Internal tag reader can be used for setting/unsetting, entry control or access control. Refer to the installation
manual for all connections.
Tag Area (Where a valid tag must be presented to set/unset)
Alert LED
Alarm LED
Tamper LED
Fault LED
Unset LED
The External Tag Reader (EUR-108)
The Internal Tag Reader can be used for setting/unsetting, entry control or access control. Refer to the installation
manual for all connections.
To set/unset the system using the External Tag Reader, present a pre-programmed tag to the
centre of the prox.
The prox will display the system status: Green = Unset. Red = Set. Present the tag again
within 10 seconds to set and unset the system.
Please note: The system will set depending on the type of exit mode programmed
(Final door, Timed or Push to set)