background image

Step 1

Step 2

Install metal ground stake for center post

Measure and mark the half way point on Metal ground stake (E) 

as shown in Figure 1 below. Place Stake (E) in desired location for 

Center Post (B) and carefully use a hammer to drive it into ground. 

Use level to make sure the stake is straight and plumb. Adjust as 

needed and finish driving it into the ground using a small block of 

wood on top of stake as shown in Figure 2 below. 

Install no deeper 

than the half-way point. 

Fig. #1

Fig. #2

Step 3

Set ground stake tabs into place 

Use a flat head screwdriver and/or a set of pliers to bend the 

locking tabs on Metal ground stake (E) into appropriately a  

45 degree angle as shown in Figure 3 below.  

Fig. #3

45˚

Before you start

IMPORTANT Check for underground services with your local authorities BEFORE installation of this product. 
They will typically mark out underground cables/gas etc at no charge.

Set the fence in the desired location and carefully measure and 

mark the ground where the center of each post will fall assuring that 

each rail will set at a 45 degree angle as shown below.

45

˚

45

˚

Содержание Pottsville

Страница 1: ...iers Screwdriver Square bit 1 Power screwdriver Square bit 1 recommended Small block of wood COMpONeNtS Part Description Qty A Side sections 2 B 48 Center post 1 C 39 End posts 2 D Post caps 3 E Metal ground stake no dig 3 F Stainless steel screws 12 Square bit 1 1 F A A C C B D e CNRF1 10 11 12 ...

Страница 2: ...deeper than the half way point Fig 1 Fig 2 Step 3 Set ground stake tabs into place Use a flat head screwdriver and or a set of pliers to bend the locking tabs on Metal ground stake E into appropriately a 45 degree angle as shown in Figure 3 below Fig 3 45 Before you start IMPORTANT Check for underground services with your local authorities BEFORE installation of this product They will typically ma...

Страница 3: ...osts Take each of the side sections A and hold them in the position that they will be fitted to the center post Double check and carefully mark the end post C locations on the ground Remove side sections and install two ground stakes F for End posts C following Steps 2 3 and 4 Fig 4 Fig 5 Fig 6 Final post adjustment Final adjustment may require you to twist the post and ground stake so the three p...

Страница 4: ...lide the two side sections of fence down and into place between center post and end post Use twelve screws F and attach side sections using the pre drilled holes in center post and end posts Highwood products are ultra low maintenance but for information on seasonal cleaning or to see a video that explains how to remove minor scratches visit http www highwood usa com care html Care and Cleaning F ...

Отзывы: