54
Rescan
Clicking rescan will force drivers to report array status. For any disk(s) you hot plug
into the device, do not click rescan until all physical drives are detected and appear
under Logical Device Information.
Beeper Mute
The controller emits a beeping sound whenever an
•
Array falls into
critical
status
•
Array falls into
disabled
status
•
You unplug a disk
•
Your disk fails due to bad sectors
•
SMART sensors anticipate drive failure
If device is currently beeping, clicking Beeper Mute will mute the sound immediately.
Note
: This button does not permanently mute the alarm. To permanently mute the
alarm go to
Setting
>
Enable audible alarm
>
Disabled
.
Appendix B-4: Setting Tab
System Settings
Enable auto rebuild (default: Enabled)
When a physical drive fails, the controller will take the drive offline. Once you re-
insert or replace the disk, the controller will not automatically rebuild the array
unless this option is enabled.
Enable continue rebuilding on error (default: Enabled)
When enabled, the rebuilding process will ignore bad disk sectors and continue
rebuilding until completion. When rebuild is finished, the data may be accessible but
data inconsistency due to ignored bad sectors may cause problems in the future. If
this option is enabled, HighPoint recommends user to check the event log for bad
sectors.