60
network will be unable to remotely log in to the WebGUI.
Rebuild Priority (default: Medium)
You can specify the amount of system resources you want to dedicate to rebuilding
the array. There are 5 levels of priority [Lowest, Low, Medium, High, Highest]
Port Number (default: 7402)
The default port that the HighPoint WebGUI listens on is 7402. You may change it to
any open port.
Password Setting
Changing your WebGUI password
Under Password Setting type your new password and confirm it, then click submit
.
Email Setting
You can set the controller to send an email out to recipients of your choosing when
certain events (refer to Event Tab) trigger.
Appendix A-5: Recover Tab
Previously created arrays will be stored under this tab. Recovering an array from here
will attempt to recover a ‘
disabled’
array and make it ‘
normal’
.
The Recover List will list all your previous and current created arrays. Each entry will
list the following properties:
