Highlight 200201, Руководство пользователя

Страница: 14 / 32

13
Ordercode: 200201
TF-300 Fresnel CW
Control Modes
There are 2 modes: ● Manual control
● DMX512 (1CH, 3CH, 5CH)
One Fresnel (Manual control)
01)
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) When the Fresnel is not connected with a DMX cable, it functions as a stand-alone device.
05) Please see page 19 for more information about the Manual control mode.
Multiple Fresnels (DMX Control)
01)
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) Use a 3-pin XLR cable to connect the Fresnels and other devices.
05) Link the units as shown in fig. 06. Connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
06) Supply electric power: Plug electric mains power cords into each unit's PowerCON socket, then plug
the other end of the mains power cord into proper electric power supply sockets, starting with the
first unit. Do not supply power before the whole system is set up and connected properly.
Multiple Fresnels DMX Set Up
Fig. 06
Note: Link all cables before connecting electric power