MS-5
Electronic Pet Collar
OPERATING INSTRUCTIONS
For Use With
Power Pet Doors • Sound Barrier • Yard Barrier
Страница 1: ...MS 5 Electronic Pet Collar OPERATING INSTRUCTIONS For Use With Power Pet Doors Sound Barrier Yard Barrier ...
Страница 2: ...lled If the battery is not already pre installed in the collar install the battery by following the instructions on next page 2 Fitting the MS 5 Electronic Collar on Your Dog Place the collar on your pet with the electronics at the throat as shown When properly fitted the receiver collar should not move on the dog but also should not be overly tight You should be able to fit your fingers between t...
Страница 3: ...G THE MS 5 BATTERY 1 Unscrew the bottom cover 4 Remove and replace B3V1A battery 2 Pry bottom off at the location shown here using a small flat blade screw driver or metal nail file 3 Remove bottom note battery orientation 5 With new battery installed close case Squeeze until bottom flush with top by squeezing top and bottom together 6 Insert and tighten screw ...
Страница 4: ...lar Clean the bottom edge of the collar before opening the case to replace a battery Also thoroughly dry the collar before opening it A blow dryer can be used After opening the case clean any visible dirt off the inside lip of the case and the gasket on the bottom cover Finally blow off any remaining lint or fibers Then insert the battery and close it up Keep the inside of the collar dry Each time...
