NHC-609
4 Bars & 2 Shelves 1 Pants (32mm)
www.himart.co.nz
3C/89 Ellice Rd. Glenfield, North Shore
Shop 2, 2 Bishop Dunn Pl. Flat Bush
Ph) 4449114, 9486440
Since 1999
Making the Pillar Stand
Pillar and Component Setting
Product Size : 217cm (width), 170~253cm (height), 32cm (depth)
Spring operation
makes it go up
about 2~3cm higher.
Set up the pillar after
inserting lower pillar
in the below fixation
board.
Fasten the safety
bolt( ) with hands.
Set up the pillar lean-
ing upper pillars to-
ward the wall a little.
Move pillars to the setting place. Hold lower pillar and
upper pillar, one pillar with one hand, pull the pillar toward
the ceiling and fix it on the ceiling and bottom accurately.
The pillar is fixed strong due to the spring operation of the
upper fixation board (attach it on the ceiling by pulling
about 2~3cm with possible power)
After setup the pillar, fasten the safety bolt with hands at
one touch fixation device for use safety.
Explanation on pictures
Notice If you do not tight upper pillar, it may fall.
Please strengthen the power given to the top of pillar.
upper pillar
lower pillar
Basket shelves
Hanger
horizontal bar
Open circle
holder
approx 75cm
approx 75cm
approx 75cm
Pillar 1
Pillar 3
Pillar 4
►Arrange pillars at the same space in making pillars stand.
►After leveling respective holders, set up parts as shown in
picture.
►After regulation open holder to the wanted height with
rubber ring, fasten safety bolt at the back.
►Please push down
the Pants hanger
bar into the Pants
hanger bar holder.
Products have different colours but setting method is same.
Open circle
holder
Safey bolt
Hanger
horizontal bar
Basket shelves
holder
Pants hanger
Pants
hanger bar
Basket shelves
Basket shelves
holder
Pillar 2
one touch
fixation device
Pants hanger
bar holder
Pants hanger bar holder
Pants hanger bar
