FRU Replacement Guide
3 Controller Node Replaceable Units
28
SUBSYSTEM=="net", ACTION=="add", KERNELS=="
0000:01:00.1
", KERNEL=="eth*",
NAME="
eth2
"
SUBSYSTEM=="net", ACTION=="add", KERNELS=="
0000:01:00.2
", KERNEL=="eth*",
NAME="
eth3
"
SUBSYSTEM=="net", ACTION=="add", KERNELS=="
0000:01:00.3
", KERNEL=="eth*",
NAME="
eth5
"
SUBSYSTEM=="net", ACTION=="add", KERNELS=="
0000:81:00.0
", KERNEL=="eth*",
NAME="
eth1
"
SUBSYSTEM=="net", ACTION=="add", KERNELS=="
0000:81:00.1
", KERNEL=="eth*",
NAME="
eth4
"
SUBSYSTEM=="net", ACTION=="add", KERNELS=="
0000:82:00.0
", KERNEL=="eth*",
NAME="
eth6
"
SUBSYSTEM=="net", ACTION=="add", KERNELS=="
0000:82:00.1
", KERNEL=="eth*",
NAME="
eth7
"
If they do not match, update
/etc/udev/rules.d/70-persistent-net.rules
to match the output
of the command above, then reboot the node again.
reboot
The chassis replacement procedure is done.
Warning:
Be very careful when recording and updating MAC addresses. A mistake may render the new
chassis unusable.
Item
Value
Virtual IP Address of the Management Node:
Get this value as instructed in the
Administrator
Interfaces
chapter in the
HGST Active Archive System
Troubleshooting Guide
IP Addresses of the Other (Non Failed) Controller
Nodes:
Original Hostname of Node:
Get this value from the CMC
before
you shut down
the failed node. This value is typically of the format
SystemID
-DC
nn
-R
nn
-CN
nn
.
Temporary IP Address of Node:
The CMC displays this value
after
the new chassis is
installed.
Temporary Hostname of Node:
The CMC displays this value
after
the new chassis is
installed. This value is of the format
PM-
MAC_ADDRESS
.
MAC Address of Node:
IPMI IP Address of Node:
IPMI MAC Address of Node:
