Heyner BigAir30L PRO, Инструкция по эксплуатации, Страница: 4 / 8

ENGLISH ENGLISH
READ CAREFULLY!
Unless directions are
followed, physical injury or
property damage may result.
When using the compressor,
never leave it unattended.
1. Power required: 12 volts 10
amps. D.C.
2. This compressor is
designed for occasional
use only. Operation over an
extended period of time
will overheat the unit and
damage the compressor.
A sluggish operation of the
compressor or if the
exposed metal fi ttings get
too warm to the touch
should indicate to you that
the unit has been operating
too long and is overheating.
When this occurs stop, the
unit immediately and let it
cool for approximately
10 min. before resuming
operation.
3. This compressor is not
designed for infl ating high pressure tyres such as
used on trucks, trailors or
tracktors.
4. When running at more than
5bar/75 PSI do not operate
for more than 7 minutes.
5. You may use a 12 volt
battery charger to power
this compressor, but it
must be rated at 15 amps
or more to avoid damage
to the compressor and
for the charger.
TO INFLATE TIRES
1. Place connector on input
valve stem (Fig.1) and push
down. Close thumb latch
connector (Fig. 2).
Caution: Make sure the
connector always touches
the core of tire valve stem.
2. Plug power cord into
cigarette lighter
receptacle (Fig.3) and
switch on the compressor.
3. When proper pressure is
reached switch off the
compressor, unplug power
cord and remove connector.
4. Always leave the the
thumb lock in the open
position when storing the
compressor.
Pic. 1 Pic. 2 Pic. 3
FOR INFLATABLES
1. Select the suitable adapter
and insert it into the
connector (Fig.4).
2. Check our TYPICAL
INFLATION PRESSURE
chart. This chart is for
reference only and you
should consult your
owner´ s manual for a more
exact pressure rating.
3. Insert adapter into article
to be infl ated (Fig. 5).
4. Plug power cord into
cigarette lighter receptacle
(Fig. 3). Turn on switch.
5. When proper pressure is
reached, turn off
switch, unplug power cord.
6. Remove adapter from
infl ated article and
remove adapter from
connector.
Pic. 4
Pic. 5
TYPICAL INFLATION PRESSURE
Avoid overinfl ating. NEVER
EXCEED RECOMMENDED
PRESSURE. The item being
infl ated may burst and cause
serious injury.
TROUBLE SHOOTING:
Compressor does not start/
blows fuses
1. Push the power plug fi rmly
into the receptacle and
twist it back & forth.