Wireless
Earbuds
Included
Wireless Earbuds
Micro USB Charging Cable
Pairing
Power ON using ON/OFF switch.
Rapid flashing white light, followed by a chime
Use Bluetooth settings on your phone to pair with HEYDAY EARBUD 01
Slow flashing white light - pairing successful
Indicators
Red/White Alternating - Bluetooth pairing
Slow Flashing White - Paired
Slow Flashing Red - Battery low
Red - Charging
White - Charging complete
Ascending Tones - Powering on
Descending Tones - Powering off
Three Rapid Tones - Ready to pair
Two Rapid High Tones - Paired
Two Rapid Low Tones - Low battery
Two Ascending Tones - Max. Volume
Two Descending Tones - Min. Volume
Phone call function
Press the ON/OFF switch to answer the incoming call, press the ON/OFF switch again to hang
up after the call
Press the + button to increase the volume
Press the – button to decrease the volume
The music will pause when a call comes in and will resume playing after the call has ended
Charging
Full charge requires approximately 2-3 hours
Charging is complete when solid white light turns on
Plug micro end of charging cable into earbuds
Plug USB end of charging cable into a DC 5V USB power supply
Troubleshooting and tips
If the earbuds are not working correctly, turn them on/off to reset
If the earbuds won’t turn on, recharge the battery and try again
If the earbuds won’t charge, make sure the supply works, is 5V >1A, and not damaged
If the earbuds make no sound adjust the volume
If the earbuds make no sound or do not show as an available device, make sure they are not
paired to another device, if so, unpair the device and re-pair the desired device
This device does not have a pairing code. If prompted for one make sure you are connecting to
the correct device. If you are, “forget“ the device and re-pair. If you are still prompted enter
0000
NOTE:
The unit will power off after 2 minutes of no use.
Need some help?
Can’t get it to pair? Have a question or comment?
call us at: 877-698-4883 or: 877-MyTgtTech online at: TargetTechSupport.com
Safety
Do not use near any water source
Do not modify or repair this device
Do not use in high temperatures or extreme weather
Do not use chemical detergents to clean your device, use a soft dry cloth
Keep 5-10 inches between microphone and mouth when using the phone call function
FCC ID: 2AVTM-TT2001 Model: TT2001 Input: 5V Max 1A Made in China
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and (2)This device must accept any interference
received, including interference that may cause undesired operation. Warning: Changes or
modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
●
Reorient or relocate the receiving antenna.
●
Increase the separation between the equipment and
receiver.
●
Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
●
Consult the dealer or an experienced radio/TV technician for help.
Target Corp.Mpls.MN,55403 Phone:1-612-304-6073
Left
charge port
increase volume /
hold-next track
hold on / off
play / pause /
answer/end calls
decrease volume /
hold-last track /
mute call
Right
heyday
R
