Configuration and Operations
LD900 Installation and Oper ations M anual
53
4.7.3 Receiver > Network
The LD900 is preconfigured with a static IP address of 192.168.2.91 for LAN1 and 192.168.2.92 for LAN2.
However, either IP address can be changed to a different static IP address or switched to use DHCP. The
system can also be set to operate as a Wi-Fi Access Point (AP).
4.7.3.1
Receiver > Network > LAN1 (or) LAN2
Two LAN ports are provided on the LD900 with configuration options the same on each however, both IP
addresses should not be set to the same when on static. LAN1 is available for ICOM data outputs, with LAN2
serving as a direct feed to Quantum software.
Use the arrow buttons and tick to select
LAN1
(or)
LAN2
, followed by tick. To configure DHCP click on
Edit
and
using the arrow keys and tick select
On
or
Off
as required, followed by tick. Then use the arrow keys and tick to
select
Apply
, right to select
Yes
and tick to apply the change.
When selecting
DHCP: On
, the IP Address, Subnet Mask and Gateway will auto-populate after a short period
and no f urther configuration will be required. If selecting
DHCP: Off
the IP Address, Subnet Mask and Gateway
will require configuring by clicking on the corresponding
Edit
for each and using the arrow buttons and tick to
set. Note when DHCP has been set to Off and changes have been made an additional field
Speed
will be
shown on the network page, allowing the speed to be set to either 10Mbps or 100Mbps (default).
NOTE
IP Addresses, Subnet Masks and Gateways on both the LD900 and connecting devices need to be configured
within an appropriate range, between 0.0.0.0 and 255.255.255.255.
If necessary, see FAQ
How do I configure my PC to connect to an LD900?
