User manual - Machine Automation Solution - V3R003
50 / 102
Two different behaviors are possible when selecting this option, it is necessary to previously configure the default behavior
as described below. This option is similar to
Realign
, but instead of using the vehicle/antenna location for the
adjustments, here they are made according to the values and direction manually indicated by the operator.
Figure - Manual adjustments
To define the behavior of the realignment option, proceed as follows:
1. Select the
Guidance
option in the
Configuration Menu
;
2. Select the option
Guidance settings
;
3. Select the default option in the right frame.
Figurae - Guidance settings
The following manual adjustment options are available:
·
Guide adjustment by changing the position of the GNSS
This option is selected by default. In this option when the
Manual adjustment
button is activated on the
operation screen, the equipment has manual controls so that the operator can adjust the position of the
GNSS, the adjustment is made every
2 centimeters
to the side indicated by the user.
Important
The position of the GNSS is adjusted and the original guide and its parallels remain the same.
of the guide.
·
Guide adjustment by changing the position of the guide
When the user selects this behavior, when selecting the
Manual Adjustment
button on the operation screen,
the equipment has manual controls so that the operator can move the guide in the direction and distance he
wants. In this case, a new original guide similar to the previous one will be created according to the side and
distance indicated by the operator and new parallels will be drawn. The previous original guide can be
accessed again in the guide manager, if it has been saved.
Important
The position of the guide is adjusted, creating a new original and parallel guide.
11.1.2.4 Advanced configuration
To change the
Curve configuration,
proceed as follows:
1.
Access the
Guidance
option in the
Configuration menu
;