3.
The first number is flashing. Press
Previous
or
Next
to change the value of the flashing number. When the
flashing number shows the desired value, press
Enter
to select.
4.
The screen displays the second number flashing. Repeat Step 3 until you have entered all eight
characters. Press
Enter
to select. After the last number has been entered, the password has been set to
the new password.
Setting the number of reserved slots (Configuration > Set Reserved Slot Count)
You can access reserved slots from the RMI and the OCP, but the reserved slots are invisible to the host and
backup software. For example, you might keep a cleaning cartridge in a reserved slot if your backup software
does not manage the cleaning process.
You can reserve up to 22 slots.
Prerequisites
Access to this feature requires the administrator password.
Procedure
1.
From the Home screen, press
Previous
or
Next
until the screen displays
Configuration
. Press
Enter
to
select.
2.
Press
Previous
or
Next
until the screen displays
Set Reserved Slot Count
. Press
Enter
to select.
3.
Enter the administrator password if prompted.
4.
Press
Previous
or
Next
to scroll through the display until the desired number of slots is displayed, then
press
Enter
.
Configuring the mailslot (Configuration > Configure Mailslot)
The mailslot is a single slot at the front of the left magazine that you can access without removing the whole
magazine. Loading a tape through the mailslot is faster than opening the magazine because the device does
not need to inventory the rest of the magazine slots when you use the mailslot. Also, the device can continue
to function when the mailslot is open. Access to this feature requires the administrator password.
Procedure
1.
From the Home screen, press
Previous
or
Next
until the screen displays
Configuration
. Press
Enter
to
select.
2.
Press
Previous
or
Next
until the screen displays
Configure Mailslot
. Press
Enter
to select.
3.
Enter the administrator password if prompted.
4.
The screen displays either
Mailslot Enabled
or
Mailslot Disabled
.
5.
Press
Previous
or
Next
until the screen displays
Disable Mailslot?
or
Enable Mailslot?
. Press
Enter
when the correct action is displayed.
Configuring the bar code reporting format (Configuration > Barcode Format Reporting)
You can configure how the tape bar code is displayed in the OCP and RMI, and how it is reported to the host
software. You can configure the number of characters to display and whether to justify the numbers to the left
or right. For example, when reporting only six characters of the bar code label
12345678
, if alignment is left,
the device will report
123456
. If alignment is right, the device will report
345678
. The maximum length is 15
Setting the number of reserved slots (Configuration > Set Reserved Slot
Count)
105
