Hewlett Packard Enterprise Smart Array P416ie-m SR Gen10 Controller, Руководство пользователя

Страница: 24 / 75

When installed in an operational frame, the module automatically powers up and performs a series of Power On Self-Tests.
3. Observe the following actions during startup:
• All LEDs might flash amber, blue, off, and then green during the first two seconds while the connection module is
powering up.
• The green Health LED remains static when the frame link module powers up the SAS connection module.
• Fans will slowly ramp up (9 minutes maximum) until the connection module firmware boots up.
4. If the Health LED is flashing amber or off, do one of the following:
• To ensure that the connection module is seated properly, remove the module from the frame Interconnect Bay and
reinstall it by pressing firmly on the module and the locking latch handle.
• Verify that the frame has enough available power to power on the connection module.
• Verify that the connection module is installed in interconnect bays 1 or 4.
• Check the connection module status in HPE OneView.
HPE Synergy D3940 Storage Module installation guidelines
• Installation of the HPE Synergy D3940 Storage Module into the frame without drives requires one person.
• Installation of the HPE Synergy D3940 Storage Module into the frame with drives requires two people.
• Install the HPE Synergy D3940 Storage Module in any two adjoining frame bays.
• Make sure the storage module fits in the available frame bays.
• The drawer power LED will not illuminate green until a compute module containing one or more logical JBODs that are
assigned to the HPE Synergy D3940 Storage Module is powered on.
24 Deployment