Hewlett Packard Enterprise ProLiant DL20 Gen10, Руководство по техническому обслуживанию и ремонту

Страница: 77 / 153

To replace the component, reverse the removal procedures.
Removing and replacing the M.2 SSD/dedicated iLO/serial port
enablement board
Prerequisites
Before you perform this procedure, make sure that you have the following tools available:
• T-15 Torx screwdriver
• Phillips No. 1 screwdriver
• 4.5 mm hex nut screwdriver
Procedure
1.
If installed,
remove the front bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4.
Disconnect all peripheral cables from the server.
5. Remove the server from the rack.
6. Remove the access panel.
7. Remove the riser cage.
8. Remove the M.2 air guider.
9.
If installed,
disconnect the serial port cable.
10. If installed, remove the M.2 SSD.
11. Remove the standoff screw from the enablement board.
Removal and replacement procedures
77