Hewlett Packard Enterprise OfficeConnect 1850 2XGT, Руководство по установке и началу работы

Страница: 30 / 56

Configuring the Switch
Using the IP Address
3-2
8. Click Apply to implement the new password, and then click Save Configuration at the top of the
browser configuration screen to save your settings and retain them when the switch is rebooted.
See the
Hewlett Packard Enterprise 1850 OfficeConnect Switch Series Management and Configuration Guide
for more switch configuration information.
Using the IP Address
If the switch does not acquire an IP address via the DHCP request, it defaults to the following configuration:
To communicate with the switch using the 192.168.1.1 address:
1. Connect a PC directly to any of the switch’s network ports using a standard Ethernet cable.
2. Configure the PC’s IP Address and Subnet Mask to allow it to communicate with the switch through your
PC’s Web browser.
For example, for Windows 7, follow these steps:
a. Click Start, and then click Control Panel. In the Control Panel, click Network and Internet and then
Network and Sharing Center.
b. Click Local Area Connection, and then click Properties. If you are prompted for an administrator
password or for a confirmation, type the password or provide confirmation.
c. Click Internet Protocol Version 4 (TCP/IPv4) and then click Properties.
3. Click Use the following IP address, and then, in the IP address and Subnet mask fields, type the IP
address settings:
a. For IP address, enter an IP address in the same range as the switch’s IP address, for example,
enter 192.168.1.12.
b. For Subnet mask, enter 255.255.255.0, then click OK.
NOTE:
If you cannot remember the switch’s IP address or password, you can restore the factory default settings
by following the procedure described in “
Restoring to Factory Defaults ” on page 4-3.
Parameter Factory Default Setting
Password <blank>
User name admin
IP address 192.168.1.1
Subnet mask 255.255.255.0
Default gateway not set
NOTE:
Record your PC’s current IP settings to be able to restore them later, if needed.