Hewlett Packard Enterprise HPE ProLiant XL170r Gen10, Руководство по техническому обслуживанию и ремонту

Страница: 56 / 129

To replace the component, reverse the removal procedure.
Removing and replacing a Media Module adapter
CAUTION: Before replacing a DIMM, expansion board, or other similar PCA components due to a perceived
hardware error, make sure first that the component is firmly seated in the slot. Do not bend or flex circuit boards
when reseating components.
Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure
1. Power down the server.
2. Disconnect all peripheral cables from the server.
3. Remove the server from the chassis.
4. If a secondary PCIe riser cage is installed, remove the bayonet board.
5. Do one of the following:
•
Remove the secondary riser blank.
•
Remove the secondary riser cage.
6. Do one the following:
•
Remove the primary riser blank.
•
Remove the primary riser cage.
7. Remove the Media Module screws.
56
Removal and replacement procedures