AP Provisioning |
13
3.
Check if the Member AP Received an IP address
4.
Check if the Member AP and Conductor AP are in Different Sub Networks
5.
Check if the Member AP is Supported in the Instant Cluster
Check if Auto Join is Enabled on the Conductor AP
Either one of the following conditions has to be met for the new AP to join the cluster:
n
Auto join mode must be enabled on the cluster.
n
The MAC address of the new AP must be added to the AP Whitelist table.
The AP cannot join the cluster if neither of these conditions are met.
Run the
show allowed-aps
command on the conductor AP to view the auto join setting and AP whitelist
table of the Instant cluster. If
Allow New APs
is set to
disable
, do any of the following:
n
Enable Auto join mode in the
Configuration > System > Advanced Options
page of the Instant
webUI.
n
Add the MAC address of the new AP to the AP whitelist table using the
allowed-ap <MAC address>
command.
The sample below displays the auto join setting of the cluster, generated by the
show allowed-aps
command:
(Conductor AP)# show allowed-aps
Allow New APs
:disable
AP Whitelist
------------
MAC Address
-----------
90:4c:81:c3:28:1e
90:4c:81:cf:77:34
Check if the Instant Cluster is DTLS Enabled
A DTLS-enabled Instant cluster only allows DTLS-enabled member APs to join the cluster. However if Auto
join mode is enabled on the cluster or the MAC address of the new AP is added to the AP Whitelist table, the
Instant cluster accepts a non-DTLS member AP.
Run the
show cluster-security
command on the conductor AP to view the cluster security profile of the
Instant network. If
Non-DTLS Members
is set to
Deny
, do any of the following:
n
Set
Non-DTLS Members
to allow in the
Configuration > System > Advanced Options
page of the
Instant webUI
n
Enable
Auto join mode
in the
Configuration > System > Advanced Options
page of the Instant
webUI.
n
Add the MAC address of the new AP to the AP whitelist table using the
allowed-ap <MAC address>
command.
The sample below displays the security settings of the cluster, generated by the
show cluster-security
command:
(Conductor AP)# show cluster-security
Cluster Security Profile