Hewlett Packard Enterprise Apollo 4200 Gen10, Руководство пользователя

Страница: 38 / 159

Slide the front drive cages into the chassis
After installation or maintenance, pull and hold the front drive cage rail release latches, and then slide the drive cages back into
the chassis.
Removing a drive
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives, power supplies, and internal system
components to cool before touching them.
WARNING: To reduce the risk of personal injury or damage to the equipment, adequately stabilize the rack before
extending a component outside the rack. Extend only one component at a time. A rack may become unstable if more
than one component is extended.
CAUTION: Do not operate the system for long periods with the front drive cages extended. When the front drive cages
are extended while the system is powered on, monitor the status of the front drive temp sensor (08-HD Max) in iLO. If
the iLO temp sensor (08-HD Max) reading is reporting an N/A value, monitor how long the drive cages have been out of
the chassis. Before reaching the 110 second mark, slide the drive cages back into the chassis and keep them there for at
least 300 seconds before extending them again.
Failure to observe this caution will result in improper airflow and insufficient cooling that can lead to thermal damage.
CAUTION: Do not operate the system with any of the front or rear drive cage bays empty. To maintain proper airflow
and sufficient cooling, all drive bays in the front and rear cage must have a drive or a drive blank.
Procedure
1. Back up all system data.
2. Do one of the following:
Operations
38