4
AP-303H-MNTW Wall Mount Kit | Installation Guide
4. If available, route an Ethernet cable from the wall and connect to the PT port located on the back
of the access point
Mounting the access point
5. (Optional) If there are any additional wires that are left unused for this installation, remove the
blank Keystone jack cover(s) from the AP-303H-MNTW by squeezing the tabs on either side to
disengage the clips and pull outward to remove the tab(s), as shown in
Figure 5
.
Insert a Keystone module that corresponds with the unused cable, Once the Keystone module is
clipped into the AP-303H-MNTW, connect the cable to the wall-facing side of the jack.
If the unused cable(s) does/do not have a corresponding Keystone module, the installer can
remove the panel located at the top of the plastic bracket by squeezing the clips and pulling
outward. Once removed, additional cables may be routed through the top of the AP-303H-MNTW
for continued use.
Figure 5
Removing Keystone jack covers and
6. Align the mounting slots on the back of the 303H access point access point with the corresponding
posts on the AP-303H-MNTW wall mount, as shown in
Figure 6
. Press the access point into the
mounting bracket and pull downward to engage the pins with slots.
UP