15
LED Designations and Layout
1. Be sure that all safety measures required by the
equipment manufacturer have been followed.
2. Turn on power to the receiver. The CPU Standby
LED (1) should flash yellow to indicate the
microprocessor is working properly.
3. Place the key switch on the transmitter in the
OFF position and the E-Stop pushbutton in the
OFF position (i.e. pull it out).
4. Place a fully charged battery pack into the battery
compartment located at the back of the
transmitter.
5. Turn the key switch to the ON position. The
Power LED on the transmitter flashes GREEN
once and an acoustic pulse sounds to indicate
there is a diagnostic test in progress.The LED on
the transmitter continuously flashes GREEN and
a second acoustic pulse sounds to indicate
successful diagnostic testing.
6. Immediately following the diagnostic test, the
Receiver Transmission LED (2) should flash. This
indicates that the receiver is detecting a valid
signal from the transmitter.
7. Pull out the E-Stop pushbutton. The Receiver
E-Stop Relay LED (5) should illuminate.
8. Push in the E-Stop pushbutton. The E-Stop Relay
LED should go off.
9. Pull out the E-Stop pushbutton.
10. Press the Start pushbutton on the transmitter.
The Start Relay LED should illuminate. The main
line contactor will activate at this time (depending
on crane wiring).
11. Activate the motion pushbuttons to test the
crane/machine functions.
IMPORTANT:
The crane/machine functions will
operate during this check. Be certain that there are no
obstacles near the crane/machine.
12. Confirm that the crane/machine moves
appropriately and that the correct LEDs illuminate
for each crane/machine motion.
13. Activate the Option functions, if supplied, to test
optional crane/machine functions.
R
F1
F2
Emergency
Stop
M32
M25
M20
K1
K2
K3
K
K5
K6
K
K8
K15
K16
K17
K18
K19
K20
1
2 3 4 5 6 7 8
1
2 3 4 5 6 7 8
1
2 3 4 5 6
1
2 3 4 5 6 7
8
1
2 3 4 5 6 7 8
1
2 3 4 5 6
9 10 11 12
9 10
1. CPU Yellow LED
2. Transmission Green LED
3. E-stop Fault Red LED
4. Telegram Type Red LED
5. E-stop Relay Activated Red LED
6. Output Relays K1 - K20 Activated
Red LEDs
5
6
2
3
1
4
Option
1
Option
2
E-Stop
Switch
Key
Switch
Power LED
