USE
R’S MANUAL |
ERGO-S
18
7.2 Charging Unit
The charger docking station base can be dismantled from the bench-top state to obtain a wall-mount charger instead.
Figure 14. Bench-top or wall-mount variations
7.2.1 Removing the grippers
In order to obtain the wall-mount version and mount it to a wall/panel, the grippers must be removed by following the below steps:
1. The gripper is to be pressed firmly downwards (towards the charger) until the gap is minimized as much as possible.
Figure 15. Pressing the gripper downwards
2. The gripper clip is to be pressed firmly inwards.
Figure 16. Pressing the clip inwards
3. The gripper is to be pulled upwards whilst keeping the clip pressed inwards.
