28
HE 5760 Operating Instructions
# 372449| Version 3.2
9 Parameterisation
The setting of the control to the real filter system is made with the information under the
parameters. With this information, the controller expects a very specific number of valve
controls to which a specific number of valves and sensors must be connected. Any deviation is
reported as an error.
The parameters are called up from the actual value screen with the context key .
The individual parameters are sensibly combined in parameter groups.
Navigation within the groups is done page by page with the left and right keys. The selection
of a group is indicated by the inverted display, the selection, i.e. the call of the individual
parameters, is made with the Enter key. Use the up and down keys to enter the required
values or select settings. The Enter key accepts the change, the ESC key allows you to cancel
the entry at any time without making a permanent change.
After parameterisation, the control unit searches for the defined units and transmits their
parameters.
9.1 Smarttool
The parameters can also be changed via PC and the programme 'SmartTool'. The programme
can be used to save a changed configuration or to restore a saved configuration.
Connect the PC to the control unit via USB cable, start SmartTool.exe and transfer the files or
data.
A manual for the most important programme functions is available. The programme in its basic
version is free of charge. The USB port of the HE 5760 for exchanging parameter data. The
plug must not be set to flash.
Parameter menue
Systemparameter
Local Control
Valve control
Cleaning cycles
Chamber Control
Operation time
Service
Passwords
Measuring ranges
Malfunction monitor
DeltaP control
