HERZ 3 F799 06
Page 5
ITCS (Optional)
The thermostat Intelligent Temperature Control System will activate your installation in advance to
assure the desired temperature at the hour programmed following your weekly program.
This automatic control system works in the following way:
When you start your thermostat for the first time, it will measure the time taken by your installation
to reach the set temperature. The thermostat will re-measure this time at each program change to
compensate external temperature change & influence. You can now program your thermostat
without the need to adjust the temperature in advance because your thermostat does it
automatically for you.
Radio Configuration
1. To assign the
MILUX
RF
thermostat with the rece
iver you must put the receiver in “
RF
init
”
mode, please refer to the receiver leaflet. (*)
2. On the
MILUX
RF
, select
operating mode. Then press the (Ok) key during 5 seconds,
you will enter in the Radio configuration mode “
“ must be displayed. The
thermostat is now sending by radio signal its configuration signal.
3. Check on the receiver the good configuration (see the receiver leaflet for more information)
4. You can now perform a radio range verification. Place the MILUX RF in the room where you
need to regulate the temperature and leave it in Radio configuration mode ( ). Close the doors
and come back to the Receiver. Verify that the RF LED blinks at each radio signal received:
- If it blinks regularly 4 times per second, the installation of the MILUX RF and Receiver is
correct.
- If it blinks irregularly or never, you are at the range limit. Try to Install the receiver closer to
the thermostat.
5. On the MILUX RF press on the (Ok) key to exit the radio configuration mode. Now your
MILUX RF can controls the Receiver.
* (In this mode it is better that the thermostat is close to the receiver)
Technical Characteristics
Operating temperature
0°C - 50°C (o 32°F
– 122°F)
Set temperature precision
0.5°C (or 0.5°F)
Regulation characteristics
Cycle (PWM): 15 minutes for 2°C
With Anti-short cycle of 3 minutes in OFF and 2 minutes in ON
Electrical Protection^
Class II - IP30
Batteries & Operating life
3x LR6 AA 1.5V alkaline batteries (> 2 years)
IMPORTANT: You have 1 minute to change the batteries.
Past this time, you may have to reprogram your thermostat if
all segments lit up at power up.
Radio Frequency
433.92 MHz, <10mW.
868.3 MHz, <10mW
RF Certifications
EN 300220-1, -2
EN 301489-1, -3
All
specifications and statements within this document are according to information available at the time of printing and meant for informational
purpose only. Herz Armaturen reserves the right to modify and change products as well as its technical specifications and/or it functioning
according to technological progress and requirements. It is understood that all images of Herz products are symbolic representations and
therefore may visually differ from the actual product. Colours may differ due to printing technology used. In ca
se of any further questions don’t
hesitate to contact your closest HERZ Branch-office.
